Have I K-od the micro-switch, circuit board? Closest I found was the c but that did not work. That printed out completely uniformly. Then you can turn on the printer. The service station is really gummed up with ink. This is the best printer you can buy IMHO. I have tried the tape on the back method to clear the memory but that did not help
|Date Added:||15 January 2014|
|File Size:||9.8 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
My Deskjet c seems to go through color ink cartridges in a hurry, even if I always say “Black and White” in the printing preferences control panel. I had figured that the black and standard color cartridges of the would duplicate what is achievable with the same setup on the C, healett apparently not, or at least that is how it appears to me.
Solved: Printer Driver for HP Deskjet c – HP Support Community –
However, there must be some communication problem between the computer and printer that it is selective in what it prints. Normally when everything appears OK and you get that griding noise it’s caused by dirt on the strip. Again, I greatly appreciate all the help you can provide me with regarding this matter. Eger on Mar 30, at 6: Ordering over the Internet would be fine. Text still seems 722 be okay in plain mode.
The printer cartridge does not move when i print a document. Warmest regards, Richard – Richard T.
When I removed the motor per your directions, there was ink inside the motor. If need be, you can physically nest the print head into rpinter right side of the printer if it doesn’t automatically do this for you. Anyone know how to get the carriage out to get to the back?
Hp Deskjet c Manuals
After finishing the installment, I made sure the belt was installed correctly by pulling it back and forth to move the ink carriage, and it worked. Alas, it continues to not print in black.
I have the same question. Eger on Nov 18, at 1: When I replaced the carriage drive belt c the carriage moves to the left and then stops.
The missing lines run the full width of the paper and are very small so that the image appears to be streaky. Because it has such a large ink cartridge and it is refillable. This can be done from a DOS prompt if DOS is opened with the “run as administrator” command, or from explorer hewlegt a copy and paste.
HP Deskjet 722c
Discussion threads can be closed at any time at our discretion. I have cleaned the mylar tape but still have the frequent problem. If this doesn’t work, then I clean the ink jets with distilled water using a Q-tip.
Have had a c since and it has been a workhorse all these years. Clean the cartridge s and carriage electrical contacts with a cotton swab and alcohol. The springs checked out OK. This started when I got a new computer with Prjnter XP. Log into the computer with 7222c administrative account.
HP Deskjet 722C Standard Inkjet Printer
I suggest reinstalling the previous set, assuming that you still have them, and see if the symptom is identical. One of my users had a service station so clogged with semi-dry ink that liquid ink was leaking on to her desk.
I’ll let Bert give you the guidance, as he’s the expert from whom I learned. Save on Printers Trending price is based on prices over last 90 days.
Remove the screw and unplug the motor cable, and the service station will lift from the front and slide out. Swish it around a bit and blot it dry with a paper towel. This printer, which I bought off of eBay, probably hasn’t been used in a long time.
Any help would be much appreciated.